Ultimate Guide For Belkin Range Extender Reset

Wifi range extenders are meant for extending internet signals to bad recipient zones as well. Belkin wifi range extender is also known for increasing the internet speed up to 300 Mbps which will make your video streaming experience even smoother. But, you might face extender configuration problems or the extender might stop mid-way. These are common issues with wifi range extenders.  You can solve any major or minor problem with your wifi range extender by resetiing it to its default factory settings. This blog will explain you how to do Belkin wifi range extender reset. 

Follow The Steps To Attempt Belkin Wifi Range Extender Reset - 

Resetting a device is the last resort because after that you will lose all the settings. You can reset the device to its default factory settings in case you have forgotten the password. Follow the below-mentioned steps to reset the Belkin wifi extender; 

Step 1: Start by finding the tiny circular button on the rear of the Belkin wifi range extender.

Step 2: Now, take a pointed object such as a pin, pen, or pencil and then press the Reset button.

Step 3: Do not release the reset button for 10-15 seconds and make sure that all the LED indicators are flashing. 

Step 4: Once you leave the reset button, reboot your Belkin wifi range extender afterward.

Step 5: After the device is properly reset, you can configure your device from the start.

Step 6: Now, install the Belkin wifi extender.

Step 7: Now, set up your Belkin range extender.

Step 8: Check the label or sticker on the bottom side of the Belkin wifi range extender to look for the username and password that have been set by default.

Follow The Steps To Set Up The Belkin Wifi Range Extender - 

After resetting the device it will go back to its default factory settings taht came originally with the wifi range extender. So you need to set your device once again to have your preferred configuration;

Step 1: Start by plugging your extender device into a functional AC wall socket and then turn on the extednder and the computer.

Step 2: After restarting the wifi extender and computing device navigato to the main wifi settings.

Step 3: From here, select the wifi extender network name or SSID.

Step 4: Tap on the SSID and connect to the Belkin wifi extender’s extended network.

Step 5: After that, launch the default web browser and it will automatically redirect you to the Wifi Range Extender Setup Page.

Step 6: Now, keep following the instructions and choose your wireless router network’s name and enter the password.

Step 7: Hit the next button to proceed further. 

Step 8: After your Belkin wifi range extender’s configuration is complete, plug it anywhere in the house and receive extended signals in every corner.

Belkin Wifi Range Extender Resetting Guide Complete!

The above blog enlightens you on how to attempt Belkin wifi range extender reset and then set it up again. By performing the Belkin range extender reset the device will go back to its default factory settings. With this, you don’t require the old passphrase to log into the wifi range extender. The username and password set by default for the wifi extender are mentioned at the back of the extender’s external body. Use the default credentials to get into the configuration settings and manage your extender.